FAQ - EZTR - The Flex vent was cut too short. What can I do?
Article Number: 248 | Rating: Unrated | Last Updated: Fri, Nov 21, 2014 9:03 AM
The Flex vent cannot be extended in length. You will have to either: 1) relocate the unit higher on the wall; 2) Use the leftover flex vent from the included roll (if possible); or 3) purchase new vent and start over. Please take care to measure vent length before cutting; it is always better to cut longer and make small adjustments to get to the correct length.
Attachments
There are no attachments for this article.
Comments
Please add a comment if you would like to provide us with feedback about this article. We will carefully analyze your feedback and use it to improve our Articles, but we will not reply to you. If you have an issue that requires a reply, please click here to contact us. If you have an urgent matter that needs immediate assistance, please call us at 866-766-7489. Otherwise, please feel free to search our website for what you need. Thank you for choosing Noritz!
Related Articles
There are no articles in this section.
Articles in same category
FAQ - EZTR - The Rain Cap will not enter to the full depth (The Rain Cap is not seating properly). What might be happening?
Viewed 2773 times since Tue, Nov 11, 2014
FAQ - EZTR - Should I caulk the Top Flex Support or Diffuser Gasket?
Viewed 2794 times since Tue, Nov 11, 2014
FAQ - EZTR - Is the EZTR vent system compatible with a universal vent cap?
Viewed 3832 times since Tue, Nov 11, 2014