FAQ - EZTR - What should I use to cut the Flex vent?
Article Number: 252 | Rating: Unrated | Last Updated: Fri, Nov 21, 2014 9:01 AM
The recommended tool is either a PVC cutter or utility knife. Avoid using a saw or any tool which can potentially leave burrs on the cut end. If using a PVC cutter, it must be compatible with cutting 2 5/16” diameter pipe.
Attachments
There are no attachments for this article.
Comments 
Please add a comment if you would like to provide us with feedback about this article. We will carefully analyze your feedback and use it to improve our Articles, but we will not reply to you. If you have an issue that requires a reply, please click here to contact us. If you have an urgent matter that needs immediate assistance, please call us at 866-766-7489. Otherwise, please feel free to search our website for what you need. Thank you for choosing Noritz!
Add CommentRelated Articles
There are no articles in this section.
Articles in same category
FAQ - EZTR - What orientation should I install the Base Junction Support?
Viewed 2510 times since Tue, Nov 11, 2014
FAQ - EZTR - The Flex vent was cut too short. What can I do?
Viewed 2796 times since Tue, Nov 11, 2014
FAQ - EZTR - Where on the flex vent should I be making a cut?
Viewed 2273 times since Tue, Nov 11, 2014
Subscribe to Article
Print Article
Email Article to Friend
Export to PDF